|
2-2-14-4-snyatie-i-ustanovka-zadnego-salnika-kolenchatogo-vala.html
2.2.14.4. Removal and installation of a back epiploon of a bent shaft
|
|
Fig. 2.130. Removal of a back epiploon of a bent shaft: 1 – bolts; 2 – epiploon
|
Turn off six bolts of fastening of a back epiploon and remove an epiploon (fig. 2.130).
Apply kremniyevoorganichesky sealant on the interfaced surfaces in the place shown in the figure 2.131. Diameter of a point of drawing 0,4–0,6 mm. Apply pure engine oil on a working edge of a new epiploon.
|
|
Fig. 2.132. Scheme of installation of a back epiploon of a bent shaft: 1 – bent shaft; 2 – back epiploon; 3 – device for installation; 4 – block of cylinders
|
Establish and press a back epiploon, using the device for installation of a detail, as shown in the figure 2.132.
|
|
Fig. 2.133. Order of tightening of bolts of fastening of a back epiploon of a bent shaft
|
Tighten bolts of fastening of a back epiploon in the order specified in the figure 2.133, the moment of an inhaling of 8,0-11,5 N · m.
| 