Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents of CO/CH in the fulfilled gases
2.2.3. Measurement of a compression in engine cylinders
2.2.4. Check of a belt of the drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Removal of sealant
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
2.2.10. Gas distribution mechanism drive chain
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the spool-type valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.17.1. Installation of a drive plate (model with the automatic transmission), a flywheel (model with the mechanical transmission)
2.2.17.2. Installation of the oil pallet
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of the drive of the mechanism of gas distribution
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

2-2-17-2-ustanovka-maslyanogo-poddona.html

2.2.17.2. Installation of the oil pallet

Fig. 2.181. Places of putting sealant on the interfaced surface of the oil pallet


Apply a continuous strip of kremniyevoorganichesky sealant on the interfaced surface of the oil pallet as shown in the figure 2.181.

Fig. 2.182. Alignment of the interfaced surfaces of the oil pallet and block of cylinders


Use a corner to level the interfaced surfaces of the oil pallet and the block of cylinders (fig. 2.182).

Fig. 2.183. Order of tightening of bolts of fastening of the oil pallet


Tighten back bolts of fastening of the oil pallet in the order specified in the figure 2.183.
Inhaling moment: 20–30 N · m.

"previous page
2.2.17.1. Installation of a drive plate (model with the automatic transmission), a flywheel (model with the mechanical transmission)
following page"
2.2.18. Assembly of a head of the block of cylinders