Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General information
3.3.2. Design and operation of the mechanism of transmission
3.3.3. System of electronic control (RSM)
3.3.4. Mechanism of switching of the automatic transmission
3.3.4.1. Principle of operation of the mechanism of switching of the automatic transmission
3.3.4.2. Switching blocking check
3.3.4.3. Check of blocking of the ignition key
3.3.4.4. Check of a cable of blocking
3.3.4.5. Check of the lever of the selector
3.3.4.6. Adjustment of a cable of the choice of transfer
3.3.4.7. Adjustment of the switch of range of the transmission
3.3.4.8. Removal and installation of the lever of the selector
3.3.4.9. Installation of a cable of blocking
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

3-3-4-9-ustanovka-trosa-blokirovki.html

3.3.4.9. Installation of a cable of blocking

Make sure that the lever of the selector is in situation P and the ignition key is in position of LOCK.
Press the mechanism of blocking and rest it against a brake pedal limiter arm.

Fig. 3.94. Fixing of a hook of the mechanism of blocking in an arm opening


From this situation move the blocking mechanism reliably to record a blocking mechanism hook in an arm opening, as shown in the drawing the figure 3.94.

ATTENTION
The excess or twisting of a cable of blocking at installation can negatively influence operation of the mechanism of blocking.


Fig. 3.95. Installation of a tip of a cable of blocking on a cam pin


Establish a blocking cable tip on a cam pin on the lever of the selector (fig. 3.95).

Fig. 3.96. Laying of a cable of blocking in a groove of the support plate of the lever of the selector


Lay a blocking cable in an U-shaped groove of the support plate of the lever of the selector and establish a clip (fig. 3.96).

ATTENTION
Application of effort to a blocking cable at installation of a clamp can negatively influence operation of the mechanism of blocking.

Press a blocking cable clamp before you block it.

Fig. 3.97. Removal of a pin of the mechanism of blocking


Remove a blocking mechanism pin, as shown in the figure 3.97.
Turn the ignition key in the provision of ASSORTMENT.
Install a blocking cable on the key cylinder.

Fig. 3.98. Installation of a clip on a convex part of the external case of the cylinder


Move the external case to the cylinder of a key and establish a clip on a convex part of the external case (fig. 3.98).

"previous page
3.3.4.8. Removal and installation of the lever of the selector
following page"
3.4. Driving mechanism