Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with the mechanical transmission)
3.4.8.1. Preliminary check of a power shaft
3.4.8.2. Removal
3.4.8.3. Installation
3.4.9. Removal and installation of a power shaft (cars with the automatic transmission)
3.4.10. Removal and installation of a power shaft (cars with the mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

3-4-8-2-snyatie.html

3.4.8.2. Removal

Merge transmission oil.
Remove a support of the brake mechanism.
Remove a brake disk.
Remove the spherical hinge of a steering rod end of draft.
Remove a rack of the stabilizer of cross stability.
Turn off bolts of fastening and remove the sharovy hinge of the forward lower lever (a back part).
Remove the sharovy hinge of the forward lower lever (a forward part).

Fig. 3.140. Installation of a spare nut on a power shaft


Establish a spare nut on a power shaft so that the nut was aflush from the end of a power shaft (fig. 3.140).
Strike a nut with the copper hammer to weaken landing of a power shaft in a wheel nave.
Separate a power shaft from a wheel nave.

ATTENTION
Sharp edges of a power shaft can cut or punch an epiploon. Be careful at separation of a power shaft from the transmission.


Fig. 3.141. Removal of the left power shaft from the transmission by means of a core


Separate the left power shaft from the transmission, using as the lever the core inserted between the hinge and the transmission, as shown in the figure 3.141.

Fig. 3.142. Installation of special device for keeping of semi-axial gear wheels


Install the special device for keeping of semi-axial gear wheels after removal of a connecting shaft in the transmission.

"previous page
3.4.8.1. Preliminary check of a power shaft
following page"
3.4.8.3. Installation