Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 









1e5999b2

6-2-3-udalenie-vozdukha-iz-tormoznojj-sistemy.html

6.2.3. Removal of air from the brake system

NOTE
Air needs to be deleted from a hydraulic actuator of brakes every time when tubes of the brake system were disconnected.

If the pipeline of hydraulic system is disconnected from the main cylinder, removal of air needs to be begun with the most distant from the main brake cylinder of the working cylinder and to pass to the following most distant executive cylinder until air is removed from all four cylinders.
If the point of separation is in any place, except the main cylinder, removal of air needs to be begun in a point, the closest to the place of separation and to pass to the following next executive cylinder until air is removed from all four cylinders.
Uncover the union for removal of air and attach a vinyl pipe to the union.
Place other end of a vinyl pipe in the transparent, filled with liquid container.
One person has to press a brake pedal several times and then hold it in the pressed situation.

Fig. 6.9. Weakening of the union for removal of air


The second person has to weaken the union for removal of air, merge liquid and tighten the union, using special adaptation (fig. 6.9).
The inhaling moment – forward wheels: 9,8 N · m.
The inhaling moment – back wheels: 8,8 N · m.
Repeat pumping operation until an exit of air bubbles from a tube does not stop.
Remove air from each knot as it is described above.
After removal of air, check the following:
– action of brakes;
– liquid leak;
– liquid level.

"previous page
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
following page"
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)