Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.3.1. Removal of a windshield
8.3.2. Installation of a windshield
8.3.3. External rear-view mirrors
8.3.4. Removal and installation of an external mirror with the electric drive
8.3.5. Dismantling and assembly of an external mirror with the electric drive
8.4. Seats
8.5. Conditioner and heater
8.6. Tables
 









1e5999b2

8-3-2-ustanovka-vetrovogo-stekla.html

8.3.2. Installation of a windshield

ATTENTION
The windshield can be established incorrectly if the sealant has damages or glass is pushed out by air pressure during opening and closing of doors at the lifted lowering glasses. Before the termination of an ustanvka of a windshield leave all windows open.


Fig. 8.43. Removal of the remains of an old sealant


Cut off an old sealant the razor so that thickness of the remained sealant layer on perimeter of a frame made 1-2 mm (fig. 8.43).
If the sealant in any place completely separated from a body, apply on this place after degreasing a quantity of primer and let's it dry up in an iyecheniye about 30 min. After that put a layer of a sealant 2 mm thick.
Clear and degrease a strip about 50 mm wide on perimeter of a windshield and contact surface on a body.
At installation of a reusable windshield, perform the following procedure:

Fig. 8.44. Installation of pins


Attach pins in the places marked at removal (fig. 8.44).
Establish a windshield fringing.
Apply primer for glass on glass and primer for a body on a body and a fringing, let's primer dry up within about 30 min.


Fig. 8.45. General scheme of installation of glass


ATTENTION
Do not allow hit on the contact surfaces of dirt and jellied lubricant, do not concern contact surfaces. Otherwise, primer will not have sufficient adhesion to the surfaces of glass and a body that can lead to a leak.

Fig. 8.46. The scheme of putting sealant on the surface of glass


Apply sealant on the surface of glass, as shown in the figure 8.46.
Insert pins into a body, then establish a windshield.
Press on windshield pins that they entered uvulas on a body.

Fig. 8.47. Ledge gap size


Create pressure on glass perimeter so that the size of a gap of a ledge of a fringing of glass met standard (fig. 8.47).
Install components as it should be, the return to removal
Let's sealant be polymerized completely.
Time of full polymerization of sealant: 24 h.

"previous page
8.3.1. Removal of a windshield
following page"
8.3.3. External rear-view mirrors