Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of the air conditioning system
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air duct
8.5.9. Removal and installation of the compressor of the air conditioning system
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.10.1. Removal of a bolt of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and installation of the condenser
8.5.14. Check of the condenser
8.5.15. Removal and installation of lines of coolant (LF)
8.6. Tables
 









1e5999b2

8-5-10-1-snyatie-bolta-obgonnojj-mufty.html

8.5.10.1. Removal of a bolt of the obgonny coupling

Fig. 8.70. Removal of a bolt of the obgonny coupling


At removal and installation of a bolt hold press a disk, as shown in the figure 8.70.
At installation of the new compressor of the air conditioning system replace a bolt.

Fig. 8.71. Removal of sealant from the compressor


After removal of the stator and the device of thermal protection completely remove sealant from the compressor of the air conditioning system (fig. 8.71).
Before installation apply about 1 g of silicone sealant (KE-347W sealant or similar) on the contact surface of the device of thermal protection, then accurately install it on the compressor air conditioning systems, without leaving gaps.
At installation of the new stator and device of thermal protection, replace the screw.
At installation of the new stator and device of thermal protection, replace a collar.

Fig. 8.72. Scheme of replacement of a lock ring


At installation of a new press disk, pulley of the compressor of the air conditioning system, stator or case of the compressor replace a lock ring (fig. 8.72).

"previous page
8.5.10. Dismantling and assembly of the obgonny coupling
following page"
8.5.11. Adjustment of the obgonny coupling