Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of the air conditioning system
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air duct
8.5.9. Removal and installation of the compressor of the air conditioning system
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and installation of the condenser
8.5.14. Check of the condenser
8.5.15. Removal and installation of lines of coolant (LF)
8.5.15.1. Removal
8.5.15.2. Separation of the isolating joint
8.5.15.3. Installation
8.6. Tables
 









1e5999b2

8-5-15-1-snyatie.html

8.5.15.1. Removal

Disconnect a negative wire from the rechargeable battery.
Discharge coolant.
Remove the tank of the hydraulic booster of steering.
Remove a broad tank of the cooling system
Remove a cable of the drive of a butterfly valve.
Remove an arm of a hose of the hydraulic booster of steering.
Remove in the order specified in the table. Do not allow the passage of oil from the compressor.

ATTENTION
At hit of moisture or impurity in a cooling contour, cooling ability of a contour it will be lowered, abnormal noise will also be heard. Always close traffic jams an open fitting after removal of any elements of a contour of cooling for prevention of hit of moisture or impurity in a contour.

"previous page
8.5.15. Removal and installation of lines of coolant (LF)
following page"
8.5.15.2. Separation of the isolating joint