188.8.131.52. Installation of a chain of the drive of the mechanism of gas distribution
|Fig. 2.260. Alignment adjusting a shponochny flute of an asterisk of the crankshaft on an adjusting tag
Level a shponochny flute of an asterisk of the crankshaft on an adjusting tag, then install the piston of the first cylinder in the provision of VMT (fig. 2.260)
Level adjusting tags on asterisks of camshafts so that they formed a straight line at alignment on top a horizontal surface of a head of the block of cylinders.
Establish a gas distribution mechanism drive chain.
After installation of the regulator of a chain take out a wire or the paper clip established in a natyazhitel of a chain and pull a gas distribution mechanism drive chain. Remove the installed limiter, at installation of a new natyazhitel of a chain (fig. 2.261)
Make sure that the chain of the drive of the mechanism of gas distribution has no sagging, and then again check correctness of installation of asterisks.
Turn a bent shaft clockwise on two turns, and then check the moment of opening and closing of valves.