Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.5.1. Removal
2.6.5.2. Installation
2.6.5.3. Installation of a cover of the bearing of a cam-shaft
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

2-6-5-3-ustanovka-kryshki-podshipnika-raspredvala.html

2.6.5.3. Installation of a cover of the bearing of a cam-shaft

Establish a cam-shaft in the provision of VMT of the cylinder No. 1, and establish a cam-shaft.

Fig. 2.275. Provisions of installation of covers of bearings of a cam-shaft


Establish covers of bearings of a cam-shaft in the specified provisions, as shown in the figure 2.275, and then temporarily tighten bolts of fastening of a cover of bearings No. 2 and No. 7 of a cam-shaft.

Fig. 2.276. Order of tightening of bolts of fastening of covers of bearings of a cam-shaft


Tighten bolts of fastening of covers of bearings of a cam-shaft in 2–3 passes evenly in the order shown in the figure 2.276.
Inhaling moment: 11,3–14,2 N · m.
Install other components as it should be, the return to removal.
Check a compression.

"previous page
2.6.5.2. Installation
following page"
2.6.6. Replacement of a forward epiploon of a bent shaft