Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.6.1. Removal
2.6.6.2. Installation
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

2-6-6-1-snyatie.html

2.6.6.1. Removal

Uncover the rechargeable battery.
Disconnect a negative wire from the rechargeable battery.
Take off a driving belt.
Record a pulley of a bent shaft, using special devices.
Turn off a bolt of fastening of a pulley of a bent shaft.
Cut off a knife the worker an epiploon edge.

Fig. 2.278. Removal of a forward epiploon


Remove an epiploon, using the screw-driver with the flat shliyets who is wrapped up by rags to prevent damage of an epiploon of a bent shaft (fig. 2.278).

"previous page
2.6.6. Replacement of a forward epiploon of a bent shaft
following page"
2.6.6.2. Installation