Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft Removal Installation
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body


2-6-6-2-ustanovka.html Installation

Apply pure engine oil on a forward epiploon.
Insert a forward epiploon into a forward cover of the engine hands.
Press a forward epiploon, using special adaptation and the hammer.
Press fitting depth from a forward cover of the engine of 0-0,5 mm.
Record a pulley of a bent shaft, using special devices.
Tighten a bolt of fastening of a pulley of a bent shaft.
Inhaling moment: 157–167 N · m.

"previous page Removal
following page"
2.6.7. Replacement of a back epiploon of a bent shaft