Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.7.1. Check of pressure of oil
2.7.2. Replacement of engine oil
2.7.3. Installation of an oil filter
2.7.4. Removal and installation of the oil pallet
2.7.5. Removal and installation of the oil pump
2.7.5.1. Removal
2.7.5.2. Installation
2.7.6. Dismantling, check and assembly of the oil pump
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

2-7-5-1-snyatie.html

2.7.5.1. Removal

Uncover the rechargeable battery.
Disconnect a negative wire from the rechargeable battery.
Remove the lower cover together with a mudguard.
Merge cooling liquid from the engine.
Fix a broad tank of the cooling system so that it did not prevent work.
Remove a tank of the hydraulic booster of steering with hoses.
Remove the pump of the hydraulic booster with hoses and tubes.
Disconnect the socket of the sensor of provision of a bent shaft.
Place a plait of wires of the managing director oil the valve so that it did not prevent work.
Place an accelerator rope arm so that it did not prevent work.
Remove the following:
– forward wheel (right);
– driving belt;
– case of the air filter, RSM block knot, and air duct of system of an admission;
– ignition coil;
– generator;
– pump of cooling liquid;
– gas distribution mechanism drive chain.

Fig. 2.295. Removal of the oil pump: 1 – oil pump; 2 – laying of the oil pump


Remove the oil pump and laying (fig. 2.295).

"previous page
2.7.5. Removal and installation of the oil pump
following page"
2.7.5.2. Installation