7.5.3.2. Installation of a code

Perform each procedure (1-3) during 10 with, otherwise the procedure of installation of a code will be stopped.

1. Install the ignition switch in position of ACC, and then switch off the audioblock.

2. At first press the AUTO-M button, then at the same time press the button of channel 6 approximately on 2 with until on the display indication of "CODE" appears.

Fig. 7.72. Scheme of the coding 1

3. Press the AUTO-M button again, then at the same time press the button of channel 6 until on the display rectangles appear.

Fig. 7.73. Scheme of the coding 2

4. Choose a personal code and write down it before input. If to enter number, and then to forget it, then at power off of the module the audioblock will not function.

5. Buttons of the choice of channel 1-4 are used for input of the chosen code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. You enter number during 10 pages. If indication on the display disappears, repeat procedures starting with the first.

Fig. 7.74. Scheme of the coding 3

NOTE The procedure 6 has to be performed during 10 from later procedure 5.

6. During display of a code, press the AUTO-M button, then at the same time press the button of channel 6 approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages. After indication disappears, number of a code will be established.

Fig. 7.75. Scheme of the coding 4

7. If on the display there is an indication of "Err" (mistake), repeat the procedure since 1. If the mistake at input of a code repeats three times, install the ignition switch in position of LOCK and repeat the procedure the procedure since operation 1.