Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. System of power supply
7.3. System of lighting
7.4. Screen wipers and windscreen washers
7.5. Immobilizer
7.5.1. Inclusion / blocking of function of reprogramming of a key without use of special adaptation (WDS or an analog)
7.5.2. Removal and installation of the lock of ignition
7.5.3. Procedure of reprogramming of an immobilizator
7.5.3.1. Anticreeping system
7.5.3.2. Installation of a code
7.5.3.3. Cancellation of a code
7.5.3.4. Switching off of the mode of anticreeping blocking
7.6. Checks of electric equipment
7.7. Tables
8. Body
 









1e5999b2

7-5-3-3-otmena-koda.html

7.5.3.3. Cancellation of a code

Perform each procedure (1-3) during 10 with, otherwise the procedure of installation of a code will be stopped.
1. Install the ignition switch in position of ACC, and then switch off the audioblock.
2. At first press the AUTO-M button, then at the same time press the button of channel 6 approximately on 2 with until on the display indication of "CODE" appears.

Fig. 7.76. Scheme of cancellation of the coding 1


3. Press the AUTO-M button again, then at the same time press the button of channel 6 until on the display rectangles appear.
4. Buttons of the choice of channel 1-4 are used for input of the operating code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. You enter number during 10 pages. If indication on the display disappears, repeat procedures starting with the first.
Fig. 7.77. Scheme of cancellation of the coding 2


Fig. 7.78. Scheme of cancellation of the coding 3


NOTE
The procedure 5 has to be performed during 10 from later procedure 4.

5. During display of a code, press the AUTO-M button, then at the same time press the button of channel 6 approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages. After indication disappears, number of a code will be removed.

Fig. 7.79. Scheme of cancellation of the coding 4


6. If on the display there is an indication of "Err" (mistake), repeat the procedure since 4.


"previous page
7.5.3.2. Installation of a code
following page"
7.5.3.4. Switching off of the mode of anticreeping blocking