8.2.2. Adjustment of provision of a cowl

Remove a forward wing.

Remove a forward wing.

Weaken bolts of adjustment of a loop of a cowl and close a cowl.

Fig. 8.8. Bolts of adjustment of a cowl

Twirl bolts (fig. 8.8).

Fig. 8.9. Check of a gap between a cowl and a body

Check a gap between a cowl and the case (body) in the section shown in the figure 8.9.

Gap: and – 2,5–4,5 mm.

Fig. 8.10. Adjustment of height of provision of a cowl

Rotating the adjusting screw, establish the required height of provision of a cowl (fig. 8.10).

Fig. 8.11. Height of provision of a cowl

Make sure that height between a cowl and the case (body) in the section shown in the figure 8.11 is in limits of the specified sizes.

Height:

a – 3,0–6,0 mm;

b – 3,0–6,0 mm.