Mazda 3 since 2003
	1. Operation and maintenance of the car
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
		2.7. Lubrication system
		2.8. Cooling system
		2.9. System of an admission
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. System of ignition
		2.13. Control system
			2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine
			2.13.2. Removal and installation of the sensor of provision of a bent shaft
			2.13.3. Removal and installation of the sensor of provision of a butterfly valve
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-13-1-snyatie-i-ustanovka-datchika-temperatury-okhlazhdayushhejj-zhidkosti-dvigatelya.html

2.13.1. Removal and installation of the sensor of temperature of cooling liquid of the engine

Uncover the rechargeable battery.

Disconnect a negative wire from the rechargeable battery.

Perform the following procedure for ensuring convenience of access.

Remove the air filter.

Take aside a pipe of recirculation of the fulfilled gases (from an inlet collector).

Merge cooling liquid from the engine.

Fig. 2.341. Installation of special device for removal of the sensor of temperature of cooling liquid

Install special adaptation on the sensor of temperature of cooling liquid (fig. 2.341).

Remove the sensor of temperature of cooling liquid.

Replace laying.

Establish as it should be, the return to removal.

Moment of an inhaling of the sensor of temperature of cooling liquid: 15,7–23,5 N · m.