Mazda 3 since 2003
	1. Operation and maintenance of the car
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
			2.2.1. Engines of the L8 and LF models
			2.2.2. Verification of the contents of CO/CH in the fulfilled gases
			2.2.3. Measurement of a compression in engine cylinders
			2.2.4. Check of a belt of the drive of auxiliary units
			2.2.5. General information and safety measures at removal of the power unit
			2.2.6. Removal of sealant
			2.2.7. Removal and installation of the power unit
			2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
			2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
			2.2.10. Gas distribution mechanism drive chain
			2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
			2.2.12. Check of the operating oil valve (OCV) (L3)
			2.2.13. Check of operation of the spool-type valve (OCV) (L3)
			2.2.14. The general repair operations on the power unit
			2.2.15. Check of a head of the block of cylinders
			2.2.16. Assembly of the block of cylinders (beginning)
			2.2.17. Assembly of the block of cylinders (termination)
			2.2.18. Assembly of a head of the block of cylinders
				2.2.18.1. Installation of a maslootrazhatelny cap
				2.2.18.2. Installation of a head of the block of cylinders
				2.2.18.3. Installation of cam-shafts
			2.2.19. Assembly of the drive of the mechanism of gas distribution
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
		2.7. Lubrication system
		2.8. Cooling system
		2.9. System of an admission
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. System of ignition
		2.13. Control system
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-2-18-2-ustanovka-golovki-bloka-cilindrov.html

2.2.18.2. Installation of a head of the block of cylinders

Establish a head of the block of cylinders.

Fig. 2.186. Order of tightening of bolts of fastening of a head of the block of cylinders

Tighten bolts of fastening of a head of the block of cylinders in the order designated in the figure 2.186 for six receptions.

Tighten to 5,0 N · m.

Tighten to 13–17 N · m.

Tighten to 44–46 N · m.

Tighten on 88-92 °.

Tighten finally.

"previous page
2.2.18.1. Installation of a maslootrazhatelny cap

following page"
2.2.18.3. Installation of cam-shafts