Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Check and adjustment of a pedal of coupling
3.1.2.1. Adjustment of height of provision of a pedal
3.1.2.2. Check and adjustment of a free wheeling of a pedal of coupling
3.1.2.3. Verification of the provision of switching off of coupling
3.1.2.4. Removal and installation of a pedal of coupling
3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling
3.1.2.6. Removal and installation of the main cylinder of the drive of switching off of coupling
3.1.2.7. Removal, check and installation of coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

3-1-2-5-snyatie-i-ustanovka-trubok-gidroprivoda-scepleniya.html

3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling

NOTE
For liquid of a hydraulic actuator of the brake system and coupling the general tank is used.

If tubes of a hydraulic actuator of coupling were disconnected when holding a procedure, add working liquid of a hydraulic actuator of coupling (brake fluid), remove air from system and check for lack of leak after implementation of the procedure.
Pick up the coupling hydraulic actuator phone, using special adaptation (49 0259 770B). Establish a coupling hydraulic actuator tube, using a combination of special adaptation of a dynamometer key.

"previous page
3.1.2.4. Removal and installation of a pedal of coupling
following page"
3.1.2.6. Removal and installation of the main cylinder of the drive of switching off of coupling