Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents of CO/CH in the fulfilled gases
2.2.3. Measurement of a compression in engine cylinders
2.2.4. Check of a belt of the drive of auxiliary units
2.2.4.1. Procedure of check
2.2.4.2. Replacement of a driving belt
2.2.4.3. Check of an automatic natyazhitel of a driving belt
2.2.4.4. Check of thermal gaps in the mechanism of the drive of valves
2.2.4.5. Adjustment of thermal gaps in the mechanism of the drive of valves
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Removal of sealant
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
2.2.10. Gas distribution mechanism drive chain
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the spool-type valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of the drive of the mechanism of gas distribution
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

2-2-4-2-zamena-privodnogo-remnya.html

2.2.4.2. Replacement of a driving belt

Remove the right mudguard.

Fig. 2.75. Weakening of a tension of a driving belt


Turn the center of a pulley of a natyazhitel clockwise to weaken a tension of a driving belt (fig. 2.75).
Take off a driving belt.
Repeatedly establish a driving belt or establish a new driving belt.

Fig. 2.74. Check of a tension of a driving belt


Check the provision of a tag of the indicator of an automatic natyazhitel of a driving belt (see fig. 2.74).
If the provision of a tag does not meet standard, replace a driving belt.
Establish a mudguard into place.

"previous page
2.2.4.1. Procedure of check
following page"
2.2.4.3. Check of an automatic natyazhitel of a driving belt