Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. General information
5.2. General checks
5.3. Working operations with the steering mechanism
5.3.1. Precautionary measures during the work with system of passive safety (SRS)
5.3.2. Removal, check and installation of a steering wheel and steering column
5.3.3. Dismantling of the steering mechanism and steering drafts
5.3.4. Check of the steering mechanism and steering drafts
5.3.5. Removal and installation of the pump of the hydraulic booster
5.3.5.1. Assembly of components of the pump of the hydraulic booster
5.4. Tables
6. Brake system
7. Onboard electric equipment
8. Body
 









1e5999b2

5-3-5-1-sborka-komponentov-nasosa-gidrousilitelya.html

5.3.5.1. Assembly of components of the pump of the hydraulic booster

Fig. 5.34. Installation of a clip of the pump of the hydraulic booster


Put on a clip in the direction shown in the figure 5.34.
Make sure that the ear of a clip is recorded.

Fig. 5.35. Installation of an epiploon in a forward pump housing


Establish an epiploon in a forward pump housing, using special adaptation and the kapron hammer (fig. 5.35).

Fig. 5.36. Assembly of blades


Place blades in a rotor so that the rounded edges were included into a cam (fig. 5.36).

Fig. 5.37. Installation of a statorny ring in a forward pump housing


Establish a statorny ring in a forward pump housing by a tag (fig. 5.37) up.
After installation of the back case manually turn a shaft to check smoothness of rotation.
Establish a shaft in a forward pump housing.
Install the pump and tighten three bolts of fastening.
Install pressure sensor socket.
Establish a driving belt.
Pump over a hydraulic contour of the steering mechanism.
Check whether there is no leak and dribble of working liquid of hydraulic system.
Make check and installation of a steering wheel.

"previous page
5.3.5. Removal and installation of the pump of the hydraulic booster
following page"
5.4. Tables