|
5-3-5-snyatie-i-ustanovka-nasosa-gidrousilitelya.html
5.3.5. Removal and installation of the pump of the hydraulic booster
Take off a driving belt.
Disconnect pressure sensor socket.
Disconnect the pressure head pipeline.
Disconnect the soaking-up hose.
|
|
Fig. 5.30. Pump of the hydraulic booster: 1 – driving belt; 2 – pressure sensor socket; 3 – pressure head pipeline; 4 – the soaking-up hose; 5 – pump of the hydraulic booster
|
Turn off three bolts of fastening and remove the pump of the hydraulic booster.
|
|
Fig. 5.32. Installation of the pump of the hydraulic booster in a vice with soft sponges
|
Fix the pump of the hydraulic booster, using special adaptation (fig. 5.32).
|
ATTENTION
Use special adaptation to prevent damage of the pump when fastening in a vice.
|
Lift a clip ear, using the screw-driver with flat shliyets.
|
|
Fig. 5.33. Removal of a clip of the pump of the hydraulic booster
|
Remove a clip the screw-driver with flat shliyets and the hammer, as shown in the figure 5.33.
|
|
Fig. 5.31. Components of the pump of the hydraulic booster: 1 – pump of the hydraulic booster; 2 – pressure sensor; 3 – socket; 4 – sealing rings; 5 – the operating valve; 6 – spring; 7 – clip; 8 – a broad tank of the steering drive with the amplifier; 9 – sealing ring; 10 – back pump housing; 11 – sealing ring; 12 – clip; 13 – statorny ring; 14 – rotor; 15 – blade; 16 – side plate; 17 – sealing ring; 18 – epiploon; 19 – shaft; 20 – forward pump housing
|
Sort other components, being guided by the order specified in the figure 5.31.
| 